Install the Required Drivers and Softwareīefore being able to read from or write to the BIOS, you need to install the Intel Management Engine Components.ĭownload the Intel Management Engine System Tools v9.1 r7, which contains the tools required to flash the new bios. The FDO (Flash Descriptor Override) is in a different position depending on the model.įor the small form factor the jumper is between the Power Supply and the first PCI port, if you do not have a spare jumper you can borrow the jumper from the Password Header Pins: Locate the two pin service connector and put a jumper on it.Now that you have the machine prepared, you need to put the machine into service mode before you can proceed: Extract the zip file to a directory on your computer.Īlso download the NVME Driver which will be injected into the BIOS Image.įinally you will need UEFI Tool 0.28 to make the actual BIOS modification. Shut down the machine and remove the jumper from the FDO pins and move it back to the password reset pins if you took it from there. The BIOS modification is complete and the machine now has NVMe support. If you have not yet installed your SSD into the machine, you can do it now. Now that you have written the new BIOS you have some choices to make. The very first thing you need to understand is that you must boot in UEFI mode if you want to use the NVMe drive. Now you can install an operating system of your choice or clone one of your existing drives to your new NVMe drive and enjoy amazing performance. If you are cloning then you will also have make sure your cloned drive is using the GPT partition system instead of MBR.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |